|
Florestone Terrazzo
Model 350 NEO-Angle
Shower Bases
Architect’s
Specifications
Furnish and install Model 350 terrazzo base as
manufactured by Florestone. Shoulder will be not less than
2½" inside. Nailing flange, cast integral,
will be galvanized-bonderized steel and extend not less
than one inch (1") above shoulder on two sides for
installation. Drain body will be brass, cast integral, and
will provide for a non-caulked connection not less than
one inch deep to a two inch pipe. Base will be
manufactured of tan and white marble chips cast in white
Portland cement to produce a compressive strength of not
less than 3,000 PSI, seven days after casting. Terrazzo
surface will be ground, polished, and the entire unit
sealed to resist stains and moisture after any air holes
and/or pits are grouted. Base will be reinforced with 16
gauge wire. Removable type stainless steel strainer plate
will be supplied.
Options
Offset drain.
Additional flanges. (Drawings required)
|
Dimensions may vary ± ¼ inch. Please check
unit before installation.
Place base on a minimum ¼" bed of
mortaror plaster for warranty compliance.
|
|
|
Neo angle terrazzo shower base for corner installation,
with 12" center drain and flanges on two sides for
corner installation. Center door opening.
Click for Large View
|
Model PDF