|
MOP SINKS
|
|
Florestone
Model 10/20/30/40
Terrazzo Mop Base
Architect’s
Specifications
Furnish and install mop base as manufactured by Florestone.
Shoulder shall be not less than 4" high inside and not
less than 1¾" wide.
(For high wall model specify: “Not less then 9" high
inside and not less than 1¾" wide”). Galvanized,
bonderized steel flange will extend at least one inch above
shoulder on one, two or three sides for installation against
stud wall (specify choice). Drain body shall be brass, cast
integral and shall provide for a non-caulked connection
(lead caulked optional) not less than one inch deep to a two
or three inch pipe (specify 2" or 3"). Mop sinks
with 3" drains are supplied with a rubber seal for use
on ABS, PVC or steel pipe. Base shall be manufactured of tan
and white marble chips cast in white portland cement to
produce a compressive strength of not less than 3000 PSI,
seven days after casting. Terrazzo surface shall be ground
and polished with all air holes and/or pits to be grouted
and excess removed and sealed to resist stains and moisture.
Base will be reinforced with 16 gauge wire.
Note:
|
Specify 6" or 12" height.
|
|
Specify 2" or 3" drain size (3"
standard).
|
| Specify Model Number and size. |
Specify Right Hand or Left Hand
where applicable.
|
Dimensions may vary ± ¼ inch. Please check
unit before installation.
|
|
|
|
Note: Terrazzo is not designed to be used with anything
that is over 130 degrees Fahrenheit.
|
A
|
B
|
HT.
|
C
|
D
|
E
|
WT.
|
|
|
24" |
24" |
6" |
12" |
12" |
12" |
225 |
32” |
32” |
6" |
16" |
16" |
16" |
320 |
|
36” |
24" |
6" |
18" |
18" |
12" |
295 |
36” |
36" |
6" |
18" |
18" |
18" |
385 |
|
24” |
24" |
12" |
12" |
12" |
12" |
355 |
32” |
32" |
12" |
16" |
16" |
16" |
488 |
|
36” |
24" |
12" |
18" |
18" |
12" |
430 |
36” |
36" |
12" |
18" |
18" |
18" |
525 |
|
|
Dimensions subject to
change without notice
|
Contact Florestone Products to
verify product specifications.
|
|
|
CAD Drawings are compressed in zip format (.zip)
|
Model PDF
Installation PDF